The classical type of CO2 laser is applied very little in fractional laser applications. However, there are also applications using fractional laser CO2 and classical type shooting. We use the classical type laser application successfully in lesions involving a single small area or many intermittent areas without the need for anesthesia other than local anesthesia.
In this article, we will talk about the treatment of moles and warts with smartxide dot laser.
Lesions
- In the treatment of cholesterol plaques (XSANTELESMA) formed on the eyelids due to high cholesterol,
- In the treatment of masses in the genital area, hands and feet (such as Verruka, Condilom, Cattle),
- In the treatment of masses that are raised from the skin on the skin surface (dermal nevus, mole, senile keratosis, senile moles, papilloma, milium, dermatafibroma, epidermal nevus, trichoepithelioma),
- In the treatment of masses in the hair, beard and eyebrows,
- Pyogenic granuloma,
- Rhinophyma in the treatment of autophyma,
- In the treatment of hypertrophic scar and keloid,
- In the treatment of skin cancer precursor lesions,
- It is used in the treatment of BCC-SCC smaller than 1 cm.
Mole Treatment with Fractional Laser
Before the mole treatment with fractional laser, local anesthesia is applied to the area to be treated. Bleeding does not occur during and after the application. Recovery after mole treatment with fractional laser varies from person to person. During the healing process, an antibiotic-containing cream is applied to the treated area.
With fractional laser, mole treatment can be applied in a single session. However, in some cases, a total of 2 sessions may be required depending on the condition of the mole.
Advantages of Mole Treatment with Fractional Laser
Laser mole removal application has some advantages over other mole removal applications.
These advantages are as follows:
- Since the application takes about 20-30 minutes in total, it can be called practical.
- Moles can be both lightened and completely destroyed.
- Compared to other mole removal procedures, the probability of scarring is very low.
- The process in question is usually completed in a single session, but there are cases where it is completed in 2 sessions.
- Compared to other mole removal procedures, there is minimal pain and suffering.
- Positive results can be seen in as little as 1 week after the procedure.
Wart Treatment with Smartxide Dot Laser
Laser wart treatment is among the methods that give effective results. Some viruses form warts and as a result, vascularization occurs in the relevant area. These viruses feed themselves through vascularization. The purpose of Smartxide dot laser treatment is to dry these vessels. Not every wart treatment consists of the same process. Some treatments may be easy, while others may be difficult.
How Many Sessions Does it Take to Treat Warts with Smartxide Dot Laser?
First of all, each treatment is planned according to the patient's condition. In the treatment of warts with laser, sessions and session intervals vary. However, to give an average number, laser wart treatment is adjusted to be 1 in 21 days and 1-3 sessions.
Is Pain Felt in Wart Treatment with Laser?
Warts are fed through veins. The purpose of laser wart treatment is to dry these vessels. Thus, when the veins are dried, the warts cannot be fed and the treatment reaches its goal. A little pain may be felt during the treatment. The specialist physician who performs the procedure will make arrangements on the subject.
Post Wart Treatment Process with Smartxide Dot Laser
After laser treatment, warts swell and may turn purple. Sometimes, warts can be filled with blisters filled with water.
After the laser treatment, the warts begin to peel off in about 15-20 days, and a healthy pink skin can be seen from below. In this process, it is very important to follow all the advice of the doctor.
How Does the Laser Affect the Wart?
We mentioned that warts are fed by veins. The laser removes these vessels by heating the wart. Therefore, the nutrition of warts is impaired and warts are destroyed.
